Sony DSR-DR1000 - Manual (Page 97)

97
Troubleshooting
Error Messages
This unit is provided with a self-diagnostic function that
detects internal abnormalities. When it detects an
abnormality, it outputs an error message to the monitor
screen and indicates an error code in the time counter
display.
Note
To display error messages on the monitor screen, connect
the monitor to the SUPER connector, and set the CHARA.
DISPLAY menu item (see page 66) to ON (factory default
setting).
If an error message appears, follow the direction indicated
on the monitor screen.
Alarm Messages
When operating this unit, the unit may sometimes output
alarm messages such as the one shown below to the
monitor screen and the time counter display.
Audio problem
Symptom Cause Remedy
The REC/PB LEVEL
control knobs do not
work. The VARIABLE switch on the front
panel is set to PRESET. Set the VARIABLE switch to REC when recording, or set it to
PB when playing back.
Editing restriction
Symptom Cause
Video cannot be edited
in insert mode. This unit does not support insert mode.
ErrorXX-XXX
ERROR
XX-XXX
XXXXX XXXXX XXX
XX XXXXX XXXXX
AN ERROR HAS BEEN
DETECTED, IFORM SERVICE
OF FOLLOWING CODE:
Time counter display
Error message
Error code
Direction
Error code
Monitor screen
REMOTE!
ALARM
REMOTE MODE IS SELECTED.
SET REMOTE/LOCAL SWITCH
TO LOCAL.
Monitor screen Time counter display
Direction
Cause of
alarm