Socket Mobile SDIO - Manual (Page 15)

4. When the search is complete, a list of the discovered Bluetooth phones
will appear. Choose the phone you wish to connect to, and tap Select.
A service discovery phase will begin, about 5-10 seconds.
5. As prompted in the next screen, prepare your phone for bonding. For
instructions on setting your phone to “Bondable” or “Pairable” mode,
refer to your phone manual. Have your passkey ready, then tap Next>.
6. In the next screen, enter the passkey. Tap Reply.
Note: Exchanging
passkeys allows the
phone and mobile
computer to set up
an encrypted data
link for secure
communications.
7. The mobile phone may then either automatically accept the passkey or
ask you to enter one. If prompted for a passkey, use the same one you
entered on the mobile computer.
Ericsson T68/T68i only: When the phone asks you if you want to bond ,
select 2: Add to paired devices. Do not tap ACCEPT.
8. Tap Finish. After successfully connecting, the phone will appear in the
Bluetooth Devices folder. In the Today screen, the Bluetooth icon will
also blink. You will not need to run the Get Connected! Wizard again
unless you plan to switch between different phones.
Note: You may also switch between different phones by assigning a new
“favorite phone” in the Bluetooth Devices folder.
CHAPTER 2: BASIC SETUP | 15