Socket Mobile SDIO - Manual (Page 40)

Set up Your Bluetooth Card
Note: If you use the Get Connected! Wizard which is recommended for
normal usage, then this step is not necessary. This step would be used to
change the friendly name of your mobile computer.
1. After you insert the Bluetooth Card, the Bluetooth icon should
appear in the task tray (visible from the Today screen). Tap on the icon.
2. In the pop-up menu, select Advanced Features, then My Bluetooth
Device.
Note: If you installed
Socket OBEX, the
menu will also list
Transfer via Bluetooth.
3. In the My Bluetooth Device screen, you can modify the Friendly Name
and make any desired configuration changes. When done, tap OK.
Note:
• In normal phone connect operation, Discoverable mode is not needed
and should be disabled.
• If you do enable Discoverable mode (e.g., for ActiveSync), note that it
does not shut off by itself. To save power, remember to disable it
when not needed.
• Connectable, Use Authentication, and Use Encryption are also not
required for printing or dial-up networking applications.
• Check Use Authentication to enable the Use Encryption option.
40 | CHAPTER 4: ADVANCED FEATURES