Regulatory compliance, Compactflash card, Radio frequency interference requirements – Socket Mobile SDIO User Manual

Page 84

Advertising
background image

Regulatory Compliance

CompactFlash Card

The Socket Bluetooth Card is designed to be compliant with the rules and
regulations in locations where they are sold and will be labeled as required.
This product is type approved — users are not required to obtain license or
authorization before using.


Radio Frequency Interference Requirements
This device complies with part 15 of the FCC rules and Industry Canada
RSS 210. Operation is subject to the following conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired
operation.

This equipment is also ETS EN300 328-2, ETS EN301 489-1 and ETS
EN301 489-17 compliant. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a
commercial environment.

This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in
which case the user will be required to correct the interference at his or her
own expense.

This equipment generates and radiates radio-frequency energy. To comply
with FCC RF exposure compliance requirements, the following antenna
installation and device operating configurations must be satisfied: (1) Users
are not permitted to make changes or modify the system in any way, and (2)
connecting external antennas to the card is prohibited. This device and its
antenna must not be co-located or operated with any other antenna or
transmitter.

To comply with Industry Canada RF exposure compliance requirements,
the following antenna installation and device operating configurations must
be satisfied: “The installer of this radio equipment must ensure that the
antenna is located or pointed such that it does not emit RF field in excess of
Health Canada limits for the general population; consult Safety Code 6,
obtainable from Health Canada’s website

www.hc-

sc.gc.ca/ehp/ehd/catalogue/rpb.htm


If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,

84

Advertising