SATO CL408e User Manual
Page 20
Verify that you have the following materials when unpacking:
•
Printer
•
Power Cord
•
Extra Ribbon Core
SETTING UP THE PRINTER
Consider the following when setting up the printer:
•
Locate a solid flat surface with adequate room to set the printer. Make sure
there is enough room at the top and right-hand (facing the printer) side to
provide clearance for the label access door to swing open.
•
The location should be near the host computer or terminal. The maximum
distance for RS232 cables is 35 feet and six feet for IEEE1284 Parallel
cables. Cables can be purchased locally, and their configuration will depend
upon the host system being used.
•
For information on interfacing the printer to a host system, see
Section 6: Interface Specifications.
SATO CL Series “e” Printers
PN 9001074 Rev. B
Page 2-3
Section 2. Installation
CL Printer
Power Cable
Operator Manual
Extra Ribbon Core