SATO CL408e - Manual (Page 98)

Front Access Door latch until it releases and swing the Backing Idle Roller
out of the way.
7. Open the Print Head and feed the backing paper through the print area in the
normal manner.
8. Route the label backing down the front of the print mechanism and around the
Backing Drive Roller.
9. Wrap the backing under and around the Backing Take-Up Spindle, routing it
under the two retainer prongs.
10. Manually turn the Backing Take-Up Spindle counter-clockwise to take up all
the slack in the backing.
11. Swing the Backing Idle Roller back into position until the Front Access
Door Latch engages.
12. Close the Front Access Door until the magnetic latch engages.
13. Close the Print Head.
14. Close the Top Access Cover.
15. To remove the backing from the Backing Retainer Spindle, pull outward on
the green Spindle Handle. This will slide the rolled-up backing out from under
the two retainer prongs, allowing the label backing to be easily removed and
discarded.
General Operation
Send your data stream in the normal manner to the printer. Labels should print one
at a time, even if your print quantity command requests more than one label. As the
labels are printed and presented for the operator to remove, the backing paper will be
SATO CL Series “e” Printers PN 9001074 Rev. B Page A-5
Appendix A: Optional Features
Label Dispenser Routing, CL408e/CL412e
Backing
Take-Up
Spindle
Drive Roller
Label
Backing
Idle
Roller