SATO CL408e User Manual
Page 53
CARD COPY/FORMAT
XXXXXXX ERROR
5.
If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error
Indicates no card was regognized
Mem Full Error
Indicates that there is insufficient
memory available.
CARD->MEMORYCOPY
SATOFONT
Y/N
This selection allows you to copy SATO fonts from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional Flash ROM.
1.
Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES
NO
2.
Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
SATO FONT COPY
COPYING
3.
Press the FEED key to accept the selection. If Yes was
selected the copy process will start
SATO FONT COPY
COMPLETED
4.
Once the copy process is completed, press the FEED key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5.
If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error
Indicates no card was regognized
Mem Full Error
Indicates that there is insufficient
memory available.
CARD->MEMORYCOPY
ALL
Y/N
This selection allows you to copy the entire contents from the
PCMCIA Memory card installed in the Memory Card slot on
the rear of the printer to the optional internal Expanded
Memory.
1.
Use the LINE key to step the cursor to desired setting. If
Yes is selected, the printer will enter the Card Copy mode.
If No is selected, the display will advance to the Card to
Memory Copy All mode.
COPY START
YES
NO
2.
Confirm your selection by stepping the cursor to the Yes
selection. If you select No, the display will return to the
previous selection.
CARD->MEMORY
COPYING
3.
Press the FEED key to accept the selection. If Yes was
selected the copy process will start
CARD-.MEMORY
COMPLETED
4.
Once the copy process is completed, press the FEED key
to step the display.
CARD COPY/FORMAT
XXXXXXX ERROR
5.
If an error is encountered in the copy process, one of the
following messages will be displayed on the second line:
R/W Error
Indicates a Read/Write error occured
No Card Error
Indicates no card was regognized
Mem Full Error
Indicates that there is insufficient
memory available.
Page 3-16
PN 9001074 Rev. B
SATO CL Series “e” Printers
Section 3. Configuration