SATO CL408e - Manual (Page 25)

LOADING LABELS, TAGS AND RIBBON CL408e and CL412e
LOADING LABELS AND TAGS
1. Open the Top Access Door by
swinging it up and to the left. Open
the Front Access Door by pushing
down on the green Front Cover Latch
and swinging the door forward and to
the left. This gives access to the print
mechanism on three sides
Note: The Top Access Door must be
open before the Front Access Door
can be opened.
2. Open the Print Head Assembly by
rotating the green Head Latch
counter clockwise. The head is spring
loaded and will automatically raise to
the opened position
3. Push the Label Supply Guide to the
outside of the printer to give the
maximum label width.
4. Clear access is provided to the label
path by pulling the top of the Outside
Label Guide down.
5. If using roll labels (or tags), load the
roll onto the Label Supply Spindle
so that the printing side of the labels
faces upwards as it unwinds from the
roll. Push the roll all the way to the
inside of the printer, raise the Label
Supply Guide and adjust its position
until it fits snugly against the outside of
the label roll.
Page 2-8 PN 9001074 Rev. B SATO CL Series “e” Printers
Section 2. Installation
Front Access
Door Latch
Top Access
Door
Front Access
Door
Head Latch
Feed Slot
Label
Outside Label Guide
Label Supply
Spindle
Outside Label
Guide