SonicWALL Internet Security Appliances - Manual (Page 239)

Page 240 SonicWALL Internet Security Appliance Administrator’s Guide
SonicWALL PRO 200 and PRO 300 Back Panel
The SonicWALL PRO 200 back panel is shown below, followed by a description of each item. The
SonicWALL PRO 300 back panel is identical to the SonicWALL PRO 200.
SonicWALL PRO 200 and PRO 300 Back Panel Description
• (3) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(3) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both Ethernet and
Fast Ethernet networks. The Ethernet ports connect the SonicWALL to the LAN, DMZ, and WAN
using Twisted Pair cable with RJ45 connectors.
• Serial Port
DB-9 RS-232 Serial port for Command Line Interface support.
• Reset Switch
Resets the SonicWALL PRO 200 or the SonicWALL PRO 300 to its factory clean state. This can
be required if you forget the administrator password, or the SonicWALL firmware has become
corrupt.
• Power Input
Connects the SonicWALL to power input. The use of an Uninterruptible Power Supply (UPS) is
strongly recommended to protect the SonicWALL against damage, or loss of data due to
electrical storms, power failures, or power surges.
• Power Switch
Powers the SonicWALL on and off.
• Cooling Vents
The SonicWALL is convection cooled; an internal fan is not necessary. Do not block the cooling
vents on the SonicWALL side panels.
Cooling
Vents
10Mbps/100Mbps
LAN Ethernet Port
10Mbps/100Mbps
DMZ Ethernet Port
10Mbps/100Mbps
WAN Ethernet Port
RS-232
Serial Port Reset
Switch
5VDC, 2A
Power Input