Sampo DVE-6xx - Manual (Page 17)

16
Center Delay
This unit supports the center time delay range of 0 to 5 ms
in 1ms steps.
Rear Delay
This unit supports the surround/rear time delay range of
0 to 15 ms in 3ms steps.
p Digital Audio Out
This option sets the audio output format sent using the
unit’s optical/coaxial digital audio outputs.
Disc Audio encoding format Digital output format
Dolby Digital
(AC-3)
Bitstream (2~5.1ch) or
48kHz/2ch LPCM
(Up to 20bits)
DTS Bitstream or OFF
Linear PCM
(48/ 96kHz up to 24bits)
LPCM up to 48kHz/20bits
DVD
MPEG 2ch LPCM (16bits)
Video
CD
MPEG I LPCM
CD Linear PCM LPCM
1 In the LPCM setting, “48K” means “the maximum
output sampling rate is 48KHz”; therefore, when the
encoding sampling rate is 96KHz, the audio will be
converted to 48KHz. If “96K” is selected, then the
maximum output sampling rate is 96KHz and no
conversion will take place.
i Sampling rate: When a sound wave is converted to a
digital signal, the sound is sampled and converted to
data at a specific frequency rate. For example, a signal
with a 96 kHz sampling rate indicates that in one
second, the analog signal was sampled 96000 times to
produce the digital signal.
AC-3 (Dolby Digital)
The maximum 5.1 channels of audio used in the surround
system for movie theaters is digital data compressed by
AC-3. In order to enjoy Dolby Digital (AC-3) discs, this unit’s
digital output jack (either coaxial or optical) must be
connected to the digital input jack of a Dolby Digital (AC-3)
amplifier or processor.
-- SPEAKER SETUP PAGE --
CNTR SPEAKER
REAR SPEAKER
SUBWOOFER
CNTR DELAY >>
REAR DELAY
3MAIN PAGE
SET CENTER DELAY
-- SPEAKER SETUP PAGE --
CNTR SPEAKER
REAR SPEAKER
SUBWOOFER
CNTR DELAY
REAR DELAY >>
3MAIN PAGE
SET SURROUND DELAY
-- DIGITAL AUDIO OUT --
AC-3 >> BITSTREEM
DTS LPCM
MPEG
LPCM
3MAIN PAGE
DIGITAL AUDIO OUT SETUP
--DIGITAL AUDIO OUT--
AC-3 >> BITSTREAM
DTS LPCM
MPEG
LPCM
3MAIN PAGE
SET AC-3 DIGITAL OUT