Sampo DVE-6xx - Manual (Page 23)

22
ADVANCED OPERATION
p Repeated Playback
When the 1/ALL button is pressed, the repeated playback
is triggered and the OSD message is changed in cycles of
“ 1”, “ ALL”, and “ OFF.”
“ 1”
1 Enables the repeated playback of a chapter for a DVD
disc.
1 Enables the repeated playback of a track for a CD disc
or a VCD disc.
“ ALL”
1 Enables the repeated playback of a title for a DVD
disc.
1 Enables the repeated playback of a disc for a CD disc
or a VCD disc.
“ OFF”
1 Resumes normal play.
p A-B Repeated Playback
You are able to perform a repeated playback between any
two points of a track or a chapter.
1 Press the
A-B button during playback to set the
beginning point (A). The OSD message “A “ will be
shown on the right lower screen corner.
1 Press the
A-B button again to set the end point (B).
The OSD message “A B” will be shown. In the
meantime, the repeated playback begins between the
two points, A and B.
1 Pressing the
A-B button again resumes normal play.
The OSD message “ OFF” will be shown.
p Random Playback (only for a VCD with
PBC off or a CD-DA)
1 Press the
RANDOM button to trigger random play. The
OSD message “ RANDOM ON” will be displayed for a
few seconds. During random playback, tracks will play
randomly.
1 Pressing the
RANDOM button again, will resume
normal play. The OSD message “RANDOM OFF” will
display for a few seconds.
p Program Playback
The program playback is only available for a CD-DA or a
VCD with PBC off.
Track program
1 Press the
STOP button to stop the play.
1 Press the
PROGRAM button to program the tracks for
program playback. The following OSD message will
display:
The “P00:00” denotes the sequence and the track of
program playback. For example, if the display
denotes “P01:03”, this means that the 3 rd track will be
played first (sequence #1).
1 Use the numbers on the remote control to begin
programming. Press the corresponding track number
in the same sequence as your desired play order. For
example, to program tracks 2, 4, 6 (in the same order),
simply press key digits 2 , digit 4 , digit 6 sequentially.
i A number larger than 10 must be keyed by using [+10]
additionally. For example, “22” is keyed in by pressing
[+10] twice and then [2] once.
i
The maximum program capability is 99 tracks.
Start/Cancel the Program Playback
1 Press the
PLAY button to start the program playback
in the order that you programmed it.
1 Press the
STOP button to stop playback, press
PROGRAM to reset program order, press PROGRAM
again to cancel the program function.
1 During the program playback, the
NEXT button and
the PREV button can be used to advance to the next
programmed track or go back to the previous
programmed track.
PROGRAM P01:03