Sampo DVE-6xx - Manual (Page 28)

27
CONNECTION METHOD OF MICROPHONE (Wireless Karaoke Model Only)
l Plug the smaller end of wired microphone’s
connector into the socket of MIC. and turn
clockwise till tight ,then plug the other end
of wired microphone’s connector into MIC.
jack of the panel.
l Turn the power switch of microphone to WD
position.
Please put batteries into microphone before using it.
l Plug the emitting antenna into the socket of
microphone and turn clockwise till tight.
l Turn the power switch of MIC. to WL position.
l Make sure to power off the switch when microphone
is not being used.
l Please take off the batteries when microphone will not
being used for a long time.
l Turn and open the middle position of microphone.
l Please put batteries by following the polarity
of instruction.
i When the emitting distance of wireless microphone
become short ,please exchange both two batteries
at the same time.
Microphone
Wireless antenna
(WL)
(WD)
(OFF)
Wired Microphone
Wireless Microphone
Power Management
Battery exchange
Wired MIC connector