Sanyo DSR - 300 - Manual (Page 109)

MENU-SPECIFIC SETTINGS 2
108
English
NETWO
R
K
SE
T
T
IN
G
S
(when optional interface board is installed)
You can specify the position of motion sensors on screen
as described below. Alarm images are recorded when a
moving subject is detected at the specified position.
11
Set the motion sensor level.
[Settings] (‹ indicates default setting.)
12
Click the location where the motion
sensor is to be setup.
“ON” (displayed ) is displayed for the corresponding
sensor.
Click again to turn the sensor “OFF” (i.e., no display).
13
Click [SAVE].
The new settings are saved.
Set conditions for the display of data on the unit’s monitor
by selecting “ON” or “OFF” for each item.
z These settings apply to information displayed on the
monitor connected to the unit, not to the PC monitor’s
display information.
1
Select “ON” or “OFF” for each data
display item.
2
Click [SAVE].
The on-screen data display conditions are set or modified.
Setting motion sensors
Setting Description
‹ OFF Motion sensing is not carried out.
1 to 10
Motion sensing will be carried out. Lower values
correspond to higher sensitivities.
13 12 Setting example 11
10. DISPLAY SET
Item
Default
setting
Description
DATE ON
Sets whether the current date or recording
date will be displayed.
TIME ON
Sets whether the current time or recording
time will be displayed.
QUALITY ON
Sets the picture quality for recording or
playback.
REC
RATE
ON
Sets the recording rate for recording or
playback.
ALARM
COUNT
ON
Sets a maximum display quantity of 9,999,
and when this is exceeded, counting
restarts from 0.
ALARM
TYPE
ON
Sets the alarm recording type.
z
“ALARM” is displayed for alarm
recording.
z “PRE” is displayed for pre-alarm
recording.
1
2
e00_l8had_us_7.book Page 108 Wednesday, March 10, 2004 2:47 PM