Sony SNC-CS50N - Manual (Page 38)

A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network Menu
38
Antenna
Select one of the following antenna settings when you
use the SNCA-CFW1 wireless card (optional) or the
SNCA-AN1 wireless LAN antenna (optional)
connected to the SNCA-CFW1.
Internal: Select this when you perform
communications using the antenna built in the
SNCA-CFW1. This setting is suitable for a short-
range and omnidirectional antenna.
External: Select this when you perform long-range
communications using the SNCA-AN1 antenna
connected to the SNCA-CFW1.
Diversity: Select this when you perform both short-
range and long-range communications using the
SNCA-AN1 antenna connected to the SNCA-
CFW1. The antenna that has higher sensitivity is
selected automatically.
SSID
Type the ID to identify the wireless network you want to
access using up to 32 ASCII characters (alphanumeric).
For your security, be sure to change the factory setting.
WEP
Select On when you use the WEP (Wired Equivalent
Privacy) keys, or Off when you do not use them.
When On is selected, the WEP key setting boxes
become active. Up to 4 WEP keys can be set in the
following manner.
1
Select one of the WEP key numbers.
2
Type the same information in the WEP key and
Retype WEP key text boxes.
The length of a WEP key is 40 or 104 bit. A 104-bit
WEP key has a higher security level than a 40-bit
key. You can type the WEP key either in
hexadecimal numbers (0 to 9 and A to F) or ASCII
characters (alphanumeric).
When Type is set to Infrastructure mode, the
WEP key should be the same as that of the access
point. When Type is set to Ad hoc mode, the WEP
key should be the same as that of the
communication client.
OK/Cancel
See “Buttons common to every menu” on page 26.
Dynamic IP address notification
Tab — Notifying the IP Address
When Obtain an IP address automatically (DHCP) is
selected in the Network tab or Wireless tab, you can
send notification of completion of the network settings
using the SMTP or HTTP protocol.
e-Mail (SMTP) notification
Select On to send an e-mail when the DHCP setting is
completed.
SMTP server name
Type the name or IP address of the SMTP server for
sending an e-mail, using up to 64 characters.
Authentication
Select the authentication required when you send an e-
mail.
Off: Select if no authentication is required when an e-
mail is sent.
On: Select if authentication is required when an e-mail
is sent. Select one of the authentication methods
from the following and specify the POP server
name, User name and Password as required.
SMTP: Select when SMTP authentication is
required.
POP before SMTP: Select when POP before SMTP
authentication is required.
Note
When you set Authentication to On, make sure to select
either or both SMTP or/and POP before SMTP.