Sony Ericsson GM47 - Manual (Page 111)

3. CONTROL AND STATUS
111
LZT 123 7263 R1C
3.16 AT+CALA Set Alarm
The command sets an alarm time in the ME. An array of different
alarms can be set and each may be recurrent. If alarm setting fails,
ERROR: <err> is returned.
When the alarm is timed out and executed, the unsolicited result code
+CALV: <n> is always returned, even if the alarm is setup to be silent.
The alarm time is set in hours and minutes. Date, seconds and time zone
cannot be set.
The alarm function uses the ring type defined with the AT*ERIN
command.
The read command returns the list of current active alarm settings in the
ME.
Show returns the supported array index values, alarm types and
maximum length of the text strings.
Description Command Possible Responses
Set an alarm time in
the ME
AT+CALA=<time>[,
<n>[,<type>[,<text>
[,<recurr>[,<silent>]]]
]]
• +CME ERROR: <err>
• OK
• ERROR
Show the current
setting
AT+CALA? • +CALA:
<time1>,<n1>,<type1>,[<t
ext1>],[<recurr1>],<silent1
>[<CR><LF>+CALA:
<time2>,<n2>,<type2>,[<t
ext2>],[<recurr2>],<silent2
>[…]]+CME ERROR: <err>
• OK
• ERROR
Show if the
command is
supported
AT+CALA=? • +CALA: (list of supported
<n>s),(list of supported
type>s),<tlength>,<rlengt
h>,(list of supported
<silent>s)
• +CME ERROR: <err>
• OK
• ERROR
<time> Description
string type
value
Refer to the AT+CCLK command. Note! Only hours and
minutes are used i.e. date, time zone and seconds are not
used
<n> Description
Integer type Index identifying an active alarm