Sony Ericsson GM47 - Manual (Page 200)

GM47/GM48 INTEGRATOR’S MANUAL
200
LZT 123 7263 R1C
12.8 ATZ Reset to Default Configuration
This command instructs the DCE to set all parameters to their default
values as specified by the user. Consider hardware configuration
switches or non-volatile parameter storage (if implemented) when using
this command.
Commands included on the same command line as the Z command will
be ignored.
12.9 AT+CMUX Switch to 07.10 Multiplex Protocol
The command is used to turn on the multiplexer. Only “no transparency
is supported”. The parameter <k> is not used.
Description Command Possible Responses
Execute ATZ • OK
• ERROR
Execute ATZ=<profile> • OK
• ERROR
Show if supported and
list available
parameter range
ATZ=? Z: (list of supported
<profile>s)
<profile > Description
0 Select the user profile to restore
Description Command Possible Responses
Switch to 07.10 AT+CMUX=<transpa
rency>[,<subset>[,
<port_speed>[,<N1>
[,<T1>[,<N2>[,<T2>
[,<T3>[,<k>]]]]]]]]
+CME ERROR: <err>
Show the current
setting
AT+CMUX? • +CMUX:<transparency>,
<subset>,<port_speed>,<N1>
,<T1>,<N2>,<T2>,<T3>[,<k>]
• +CME ERROR: <err>
Show if the
command is
supported
AT+CMUX=? • +CMUX: (list of supported
<transparency>s),
(list of supported <subset>s),
(list of supported
<port_speed>s),
(list of supported <N1>s),
(list of supported <T1>s),
(list of supported <N2>s),
(list of supported <T2>s),
(list of supported <T3>s),
(list of supported <k>)
• +CME ERROR: <err>