Skylink AM-100 - Manual (Page 19)

The control panel continuously monitors the system status as well as all the
sensors status. It will monitor occurrences such as triggered sensors, low
battery sensors, malfunction sensors, or phone line failure etc.
In order to check the system status, user can press the “Status” button on the
control panel, voice announcement will be made regarding the system and
sensor status. When the “Status” button is pressed, you will be notified if any of
the following events is occurring:
- System armed or disarmed
- Any triggered sensors
- Any sensors with low battery warning
- Any sensors with failure warning
- Phone line failure
Refer to page 20 for more details regarding system failures.
Arming the System
You should arm the system when you are the last person to leave the house.
By arming the system, the control panel will call the preprogrammed emer-
gency phone numbers and the siren will sound when break-in occurs.
Caution: Only arm the system when nobody is expected to be inside the
premises. When someone is expected to be within the premises, the system
should not be armed.
To arm the system, follow the procedures below:
1. Press [Arm] button on the control panel when no sensors are triggered.
You can also use the keychain remote to arm the system by pressing button
1 on the remote.
System Status
– 17 –
OPERATION
OR
1. Press [Arm] on the control
panel or keychain remote.
2. Leave the premises
within 45 seconds.
3. After 45 seconds.
System will be armed.
Beep Beep
Exit delay 45 seconds 45 seconds later
ARM LED on. System
Armed
ADVANCED PROGRAMMING
Zone 1
SENSOR 1
Button [1]
SENSOR 2
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons for
Sensor 1
Zone LED :
Flash once
This row :
Buttons for
Sensor 2
Zone LED :
Flash twice
®
Erase Sensors
Proceed to the following to erase a sensor.
1
2
3
[PROG]
[MPIN] Enter
Programming
mode Enter master
password to
programming mode 3 beeps for v alid password.
1 long beep for invalid
password.
[9] Select erase
remote
programming After [9] is entered, some
zone LEDs will flash or
stay off. The zone LEDs
represent whether that zone
is occupied by any sensor.
**See Table D below.
Refer to the table
below to select the
remote location. Select the
sensor you
would like to
erase After you have selected the
sensor, you will hear 3 beeps
and verbal confirmation
[Zone X Sensor Y Empty
M e m o r y], where X and Y
are the zone and sensor
numbers you have selected. To erase an
occupied
sensor, press
[1] to [0].
ZONE LED DESCRIPTION
Off Zone is not occupied by any sensor
Flashes once This zone is occupied by sensor 1.
Flashes twice This zone is occupied by sensor 2.
Flashes once, This zone is occupied by sensors 1 and 2.
then twice
** Table D: Zone LED status for erasing sensors.
Step Keys Function Description Note
– 36 –