Skylink AM-100 - Manual (Page 9)

INSTALLATION
Installing the Console
You must first determine where the control panel will be located. Please follow
the criteria below to select the ideal location for the control panel.
- Place it within a few feet of an electrical outlet and phone jack
- Place it where it is easily accessible by you and other users
- Place it away from any doors or windows which could be accessed by non-
intended users
- Place it away from extreme temperature sources such as oven, stove and
away from large metal objects which could affect the wireless performance
After you have selected a location for the control panel, you are now ready to
connect all the necessary wires and ready to power up the unit.
1. Plug in the AC adapter to a nearby electrical
outlet and plug the other end to the socket
labeled “DC 12V” on the back of the control
Panel. You should hear 3 beeps and
“System Phone Failure” indicating the
phone line is not connected. PWR, ARM
and PROG LEDs should be flashing, LO
BATT LED should be on.
2. Remove the battery cover on the bottom
of the control panel with a Phillips screw
driver, and insert 4 AAA alkaline batteries
into the battery holder (note the polarity).
After inserting the batteries, the LO BATT
LED should be off.
3. Connect the phone line from the telephone
jack to the back of the control panel where
it marks “LINE”. PWR will stay on and
PROG LED will stop flashing.
4. [OPTIONAL] If you have another telephone
that will be using the same telephone jack,
you may connect this telephone to "PHONE"
outlet of the the control panel by a phone
cord. (not provided).
5. Rotate the antenna to the upright position to
ensure the best signal reception.
4
3
1
– 7 –
2
Door/Window Sensor (WD-101)
- Magnetic Contact Sensor
- For all doors or windows
- Batteries included
Repeater (RP-434)
- Extend the operation range between 2 wireless devices,
such as any sensors and control panel
- Doubles the operation range automatically between
sensors and control panel
Water Sensor (FS-101)
- Alerts you when water is detected
- Ideal for water detection in basement, under the sink, even
bathroom
Garage Door Monitor TM Sensor (GS-101)
(Available in US and Canada)
- Monitors your garage door
- Alerts you when the garage door is left open
Garage Door Monitor TM Sensor (GS-102)
(Available outside US and Canada)
- Monitors your garage door
- Alerts you when the garage door is left open
Indoor/Outdoor Motion Sensor (PS-101)
- Monitors area in a 110 degree ARC and up to 40 feet away
from the sensor
ACCESSORIES
Additional sensors and transmitters as well as add on acces sories are available
to work with your system.
T M
– 46 –