Skylink AM-100 - Manual (Page 24)

Keychain Remote
The battery of the keychain remote (Alkaline, Type 23A, 12V) needs to be replaced
when either one of the followings occurs:
1. The LED on the keychain doesn’t flash or on when a key is pressed; or
2. The operating range starts to decrease.
To replace the battery:
1. Undo the two screws on the back of the transmitter.
The bottom case will then come off.
2. Using a small screwdriver or pen, pry out the old
battery from one end.
3. Place the new battery in position. A diagram in the
battery compartment indicates which end is positive
and which is negative.
4. Close the battery cover and reinsert two screws.
OPERATION
+
-
– 22 –
When the sensor is running low in battery, the sensor will send a wireless low
battery signal to the control panel. The zone LED representing that sensor will be
on steadily, indicating sensor(s) in that zone is in trouble condition. Control Panel
will also have an announcement to advise the user the trouble condition is low
battery, such as “zone X sensor Y low battery”, where X and Y represent the zone
and sensor number. Please replace the battery of that sensor.
ADVANCED PROGRAMMING
To enable alert zone feature, follow the instructions below.
1
2
3
4
Enter Program-
ming mode Enter master
password to
programming mode 3 beeps for valid
password. 1 long beep
for invalid password.
Refer to the
diagram below to
select the
appropriate
setting.
[PROG]
when
finished. Terminate
programming
mode. PROG LED will be
off.
[8]
If alert zone is selected,
that zone LED will be on.
If it is not selected, the
LED will flash. You are
allow to make multiple
changes before terminat-
ing programming mode.
After [8] is entered,
some zone LEDs will
flash or stay on. This
indicates whether alert
zone is selected. Select Alert
Zone.
Select which
zone you
would like to
select as Alert
Zone. Disable
Alert Zone:
[1] to [5]
Enable
Alert Zone:
[6] to [0].
[PROG]
[MPIN]
Zone 1
DISABLE
ALERT ZONE
Button [1]
ENABLE
ALERT ZONE
Zone 2
Zone 3
Zone 4
Zone 5
Button [2]
Button [3]
Button [4]
Button [5]
Button [6]
Button [7]
Button [8]
Button [9]
Button [0]
This row :
Buttons to
Disable Alert Zone
Zone LED : Flash
This row :
Buttons to
Enable Alert Zone
Zone LED : ON
®
Step Keys Function Description Note
– 31 –