Samsung SWL-4000AP - Manual (Page 78)

74
⑥ If you want to upgrade AP firmware, enter “y(yes)” after “Do you really want
to upgrade the firmware via serial ?” then, press [Enter:
↵
]. Enter “y(yes)”
again after “Do you really want (y/n)?”, then press [Enter:
↵
].
The following window will be displayed.
⑦ Enter the “apfirm” after “CMD: ” then, press [Enter ↵
]
.
##################################################
AP will enter into the FIMWARE UPGRADE MODE
##################################################
>
===============================================
Boot firmware
(SST flash memory,0xBF)
2000.12.09
===============================================
Type command([go]: normal operating or [help]: help)
CMD : apfirm
↵
Enter
“apfirm”
AP Firmware can be upgraded via serial using 1k-xmode protocol.
Power must be always on during the upgrade.
Do you really want to upgrade the firmware via serial ? (y/n):y
↵
Do you really want (y/n)? y