SATO M10e - Manual (Page 35)

Section 3. Configuration
SATO M10e PN 9001101 Rev. A Page 3-13
ADVANCED MODE
An Advanced Mode is provided to make adjustments that require only occasional changes.
Since they affect the basic operation of the printer, the procedure for entering this mode is
designed to prevent someone from accidently changing the settings.
CANCEL PRINT JOB
YES NO
If the printer has a print job(s) in memory, selecting YES will
cause the job(s) to be cleared. The default selection is NO. Be
sure you want to cancel the print job(s) before selecting yes as
the job(s) cannot be recovered and will have to be retransmitted
to the printer.
1. Use the Cursor keys to step the cursor to either the YES or
NO selection.
2. Once the correct setting is selected, pressing the ENTER
key will accept the setting.
CANCEL PRINT JOB
COMPLETED
3. After the print job(s) have been cleared from memory, the
printer will beep 3 times and display a COMPLETED
message for 3 seconds and then return to the initial ONLINE
Normal Mode.
4. If you wish to change any of the settings, you must enter the
User Settings mode again by taking the printer OFFLINE
and pressing the LINE and FEED keys.
V 05.00.03.00
INITIALIZING
Displays the firmware during the initialization.
ADVANCED MODE The Advance Mode is entered by pressing the LINE key while
simultaneously turning power on. The printer will emit one long
beep after which the LINE key is released.
ZERO SLASH
YES NO
This setting determines if a zero is printed with a slash or without
a slash. This setting can also be controlled via software
commands. When YES is selected, the printer internal fonts will
have a slash through the center of the zero character.
1. Use the Cursor keys to step the cusor to either the YES or
NO selection.
2. Once the correct setting is selected, pressing the ENTER
key will accept the setting and advance the display to the
Auto Online display.
AUTO ONLINE
YES NO
This setting determines the mode in which the printer powers up.
If the YES selection is made, the printer powers up in the ON
LINE mode and is ready to print. If NO is selected, the printer
powers up in the OFF LINE mode and must be manually placed
in the ON LINE mode by pressing the LINE key before it is ready
to print.
1. Use the Cursor keys to step the cursor to either the YES or
NO selection.
2. Once the correct setting is selected, pressing the ENTER
key will accept the setting and advance the display to the
Print Offset display.