SATO M10e - Manual (Page 44)

Section 3. Configuration
Page 3-22 PN 9001101 Rev. A SATO M10e
EYE [X.XXV]
INPUT [X.XV]
EYE - When setting the “eye” threshold, the voltage must be
measured with nothing but the label under the sensor and then
again withthe printed “eye” mark under the sensor. The formula
for this is:
(High Voltage Level + Low Voltage Level) x 0.5 = Start Value
1. Insert a label into the sensor and close the Label Hold-
Down. Make sure the printed “eye” mark is not under the
sensor. Record the voltage shown on the top line of the LCD
panel. This line should have the message “EYE” on the top
line (DIP switch DSW2-2 = ON).
2. Now pull the label forward until the “eye” mark is positioned
under the sensor (the voltage reading should be at its
highest point). Record the voltage shown on the top line of
the LCD panel. The voltage ranges measured should be
within the following ranges:
Eye-Mark = 2.5V to 3.5V
Label Only = Less than 1.0V
If the measured values are outside this range, you may have
trouble in finding a value that will work properly under all
conditions. If this is the case, a higher quality label may be
needed to get adequate performance.
3. Calculate the starting point voltage using the formula.
4. Use the LINE and FEED keys to step the counter to the
desired setting. The reading will advance to a setting of 4.9
(the maximum voltage). If a value of “0.0” is set, the printer
will automatically set the level each time the printer is
powered on with labels loaded or the head is closed.
5. Once the setting is correct, pressing the ENTER key will
accept the setting and advance to the next display.
AUTO ONLINE FEED
YES NO
This selection specifies whether or not the printer will feed a
label when it is placed in the Online mode.
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime it
enters the Online mode.
2. Once the setting is correct, pressing the ENTER key will
accept the setting and advance to the next display.
FEED ON ERROR
YES NO
This selection specifies whether or not the printer will feed a
label when an error condition is cleared..
1. Use the Cursor keys to step the cursor to desired setting. If
Yes is selected, the printer will feed a blank label anytime an
error condition is cleared.
2. Once the setting is correct, pressing the ENTER key will
accept the setting and advance to the next display.