Star Trac E SERIES STEPPER E-ST - Manual (Page 13)

STAR TRAC E-ST STEPPER O WNER ’ S M ANUAL 13
(e) Use a 5/32” Hex Key and thread into the handrail (2) 1/4-28 x 3/8”
Button Head Screws into the upper handrail. Then tighten each
screw to 110 lb-in (12.4 N-m) of torque.
(f) Use a 5/32” Hex Key and thread into the handrail (2) 1/4-28 x 3/8”
Button Head Screws into the lower handrail. Then tighten each
screw to 110 lb-in (12.4 N-m) of torque.
(g) Repeat steps 3(d) - 3(f) for other side.
NOTE: If you are installing the STAR TRAC PVS entertainment sys-
tem, Refer to the PVS Install guide before you perform this step. If
you are not installing the PVS then take the Coax and the DC power
cables and return them back down the neck.
(h) Plug in the 12 pin display cable from the neck into the front dis-
play circut board at J4. Next plug in the Heart Rate cable from the
handlebars into the HR board, then plug the HR ground into the
quick disconnect tab on the diplay frame.
(i) 1st Slide the bottom of the front display under the 2 tabs at the
base the the mount. 2nd Press display against the round bar and
rotate it to the back. Careful not to pinch any wires.
Heart
Rate
Board
J4
Ground
Wire
Quick
Disconnect
Tab
1/4-28 Button
Head Screw
1 ST
2 ND