Star Trac E SERIES STEPPER E-ST - Manual (Page 27)

OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Manager Mode.
NOTE: To exit Manager Mode without saving any values or settings, press the Q UICK S TART key.
The items that you may display and change with the previous keys are:
MAINTENANCE MODE
Your Service Representative may need to check accumulated data about the past usage of your STAR TRAC E-ST STEPPER, test its
display controls, or investigate error messages. For these reasons, your Stepper is equipped with a Maintenance Mode. The
Maintenance Mode includes all of the items available through Manager Mode, plus additional items for Service and Diagnostic use. To
enter Maintenance Mode:
1. Press and hold the , and keys together.
2. A beep will sound and “MAINTENANCE MODE” will display momentarily in the Information Window.
3. Release all keys. “SERIAL NO #####” will display in the Information Window.
The following keys are available in MAINTENANCE MODE:
Upper and Lower Data Information Window S CROLL Keys: Display the next and previous parameters, respective-
ly. Keys will repeat if held.
Increase and Decrease L EVEL Keys: Adjust the value of the displayed parameter up and down, respectively, in incre-
ments of 1 unit. These keys do not save the new value - see OK Key below.
Numeric Keypad: Allows you to enter specific values for numeric parameters. These keys do not save the new value
- see OK Key below.
OK Key: Updates (saves) the values of all parameters in non-volatile memory, and exits Maintenance Mode.
NOTE: To exit Maintenance Mode without saving any values or settings, press the Q UICK S TART key.
The items that you may display and change with the previous keys are:
STAR TRAC E-ST STEPPER O WNER ’ S M ANUAL 27
Lowest Highest Default
Item Value Value Value Meaning
Serial No 0 65535 0 Serial number (set by factory)
Date 01/00 12/99 01/05 Manufacture date for the Stepper (set by factory)
Display Vers 1 01.00 99.99 N/A Display panel software version (set by factory)
Display Vers 2 01.00 99.99 N/A Display panel software version (set by factory)
LCB Vers 01.00 99.99 N/A Display panel software version (set by factory)
Units English Metric English English = units of pounds, feet,
Metric = units of kilograms, meters
Time 5 99 99 Maximum time in minutes allowed for program, excluding cool-down.
Weight 1 (Lb) 350 (Lb) 155 lbs Default (to user), typical weight in lb (UNITS=English), or kg
1 (KG) 158 (KG) 70 (KG) (UNITS=Metric).
Language N/A N/A ENGL Language is English (ENGL), Dutch (DUTC), French (FREN), German (GERM),
Portuguese (PORT), Spanish (SPAN), Swedish (SWED), Italian (ITAL) or
Katakana (KATA).