Sanyo SCP-4920 - Manual (Page 143)

Making a Ready Link Call by Entering a Number
To place a Ready Link call by entering a number:
1. From standby mode, enter the Ready Link number you want to
dial.
2. Press to place the Ready Link call. Continue holding to
take the floor and speak.
Ⅲ The contact’s name appears on the display if there is a
matched number in your Ready Link List.
3. Continue with the Ready Link call, pressing and holding to
speak and releasing it to allow others to reply.
4. When the call is finished, press .
– or –
1. Press R-Link (right softkey) or press to access the Ready Link
List.
2. Press Go to (left softkey), highlight Enter R-Link# and press .
3. Enter the Ready Link number you want to dial.
4. Follow steps 2-4 above.
Note: Ready Link numbers must contain ten digits (area code + phone number).
Your Ready Link number is the same as your wireless phone number.
Missed Call Notification for Ready Link Calls
When an incoming Ready Link call is not answered, the Missed Call
Notification is displayed on your screen.
To call the last Missed Ready Link call:
ᮣ Simply press and hold while the Missed Call Notification is
displayed. (Continue with the Ready Link call as described
previously.)
To display the Missed Ready Link Call Log:
ᮣ Press View (right softkey). To call the entry, highlight the entry
you want to call, and press and hold
. (Continue with the
Ready Link call as described previously.)
Note: When you display Missed Calls entries, you will see the icon next to the
name. The icon will remain until you make or receive a Ready Link call to or
from the entry. The icon appears next to the new missed call entry.
Section 2J: Using Ready Link 132