Sharp PG-M10X - Manual (Page 31)

29
Menu Operation
Resetting
Resetting the factory defaults
All items can be reset to the standard settings with the
exception of the followings.
• Lamp usage timer
• “KEYSTONE” adjustment values (including the
“KEYSTONE” setting value on page 32).
1
Press the remote control MENU button to
display the normal menu and then press the
cursor
ǡ / Ǡ keys to select
“INFORMATION”.
2
When the “INFORMATION” menu appears,
press the cursor
/ keys select
“RESET”, then press the ENTER button.
3
If the ENTER button is not used during
reset, press the R-CLICK/EXIT button.
Resetting the Lamp Usage Timer
When the lamp is replaced (page 37), it is necessary to set
the lamp hours of usage from the menu.
1
Press the remote control MENU button, use
the cursor
ǡ / Ǡ keys to display the
“INFORMATION” menu and set the lamp
hours of usage.
2
Display the “INFORMATION” menu, use the
cursor
/ keys to select “LAMP USAGE
HOURS RESET” and then press the ENTER
button.
3
If the ENTER button is not used during
reset, press the R-CLICK/EXIT button.
When the lamp usage timer has exceeded
1100 hours and the unit will not turn on
The power will not turn on when the lamp hours of usage
has exceeded 1100 hours. The STATUS indicator will be on
continually (page 36). Thus, the menu cannot be displayed.
In such case, replace the lamp housing, then use the
following procedure to reset.
1
Connect the power cord (page 18).
Standby status will be activated.
2
Press the INPUT SELECT and AUTO SYNC
buttons of the main unit at the same time for
5 sec. or more.
The lamp usage timer will be reset. After resetting,
the STATUS indicator (page 36) that turned on
because 1100 hours had been exceeded will turn
off.
The lamp hours of usage will be displayed on the screen
when it has exceeded 1000 hours.
To close the menu
Press the R-CLICK/EXIT button.