Sharp PG-M10X - Manual (Page 33)

31
Menu Operation
Advanced Menu Settings (continued)
Setting the COMPUTER input terminal
The COMPUTER input terminal can be switched and used
as the component video signal (YP
B P R ) input terminal.
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
ǡ / Ǡ
keys to select “COLOR”.
2
Use the cursor / keys to select
“SOURCE CHANGE”.
3
Use the cursor
ǡ / Ǡ keys to set the
“SOURCE CHANGE”.
The following can be selected.
● RGB ● YP
B
P
R
Please select “YP B P R ”.
When component video (YP B P R ) input is used, use
the optional component video cable.
Setting the Display Frame
The display frame can be set individually for each input.
1
Select the input for image selection (page
20).
2
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
ǡ / Ǡ
keys to select “VIEW”.
3
Display the frame, then use the cursor
/ keys to select “ASPECT”.
4
Use the cursor
ǡ / Ǡ keys to set the
“ASPECT” ratio.
Any of the following four different settings can be
selected for images.
● REAL (input signal projection without pixel
replacement)
● AUTO (projection after automatic input signal
zoom in/zoom out)
● DIRECT (the original aspect ratio of the image is
maintained at all times)
● 4:3 → 16:9 (4:3 aspect ratio images are projected
after conversion to 16:9 aspect ratio)
Setting Filter
This is used to set the sharpness during pixel conversion
(image compression/enlargement and video playback).
1
With the FLIP COVER of the remote control
open, press the MENU button to display the
Advanced menu, then use the cursor
ǡ / Ǡ
keys to select “VIEW”.
2
Display the frame, then use the cursor
/ keys to select “FILTER”.
3
Use the cursor
ǡ / Ǡ keys to set the
sharpness.
Setting in Accordance With Image Content
To close the menu
Press the R-CLICK/EXIT button.