Samsung Digimax U-CA 401 - Manual (Page 69)

69
Before contacting a service center
Please check the following
Symptom Causes Remedy
- Insert fresh batteries
- Connect an AC Power Adapter
- There is low battery capacity
- An AC Power Adapter is not connected
- The batteries are exhausted
- The Camera is turned off automatically.
- The Adapter plug is not connected securely
- The Camera is being used in low
temperatures
- There is insufficient memory capacity
- The memory card has not been formatted
- The memory card is exhausted
- The camera’s power is off
- The batteries are exhausted
- The memory card is locked
The camera
doesn’t switch on
The camera
power ceases
whilst in use
Batteries drain
quickly
Camera does
not take
images when
pressing the
Shutter button
- Insert fresh batteries
- Push the power button to reactivate camera
- Remove and re-insert the plug
- Keep the camera in warm conditions (i.e.
inside a coat or jacket) and only remove it
in order to take images
- After turning the camera off, insert a new
memory card or delete unnecessary image files.
- Format the memory card.
- Insert a new memory card
- Turn the camera power on
- Insert fresh batteries
- Slide the write protect switch to the
bottom of the memory card
- A picture was taken within 0.6m from the
subject without setting an appropriate
macro mode
- Taking a picture beyond the flash range
- The lens is smudged or dirty
The images
are unclear
- If the subject is closer than 0.6m, select
macro shot mode or increase the
camera to subject distance
- Take a picture within the flash range
- Clean the lens
- FLASH OFF mode has been selected.
The flash does
not fire
- Disengage FLASH OFF mode
- The date and time have been set
incorrectly.
Incorrect date
and time is
displayed
- Reset the date and time correctly.
(p.59 ~ 60 )