Sekonic L-758DR - Manual (Page 37)

-31-
6. Advanced Functions
1. Memory function
This meter can store up to nine measured values in memory for incident light and reflected light
simultaneously. This feature can be used in the following modes;
Ambient light : shutter speed priority, aperture priority or EV mode.
Electronic Flash light : cord, cordless or wireless flash radio triggering mode.
1. Press the Measuring button and take a mea-
surement. The Current measured value on the ana-
log scale will blink.
2. Press the Memory button and store the mea-
sured value in memory, and the memorized value
on the analog scale will stop blinking.
The number of values in memory is displayed on
the LCD. The memorized value is displayed on the
analog scale. By repeating this operation, up to nine
values can be stored in memory.
3. To clear the memory, press the memory clear but-
ton
@3 or switch to another measurement mode.
4. Memory Recall
To enter Memory recall mode, hold down the Mode button and press the Memory button, and
the "M" icon and number of stored measurements will blink. Rotate Jog wheel to recall memo-
rized value. To exit Memory recall mode, hold down the Mode button and press the Memory
button again, and "M" icon and number of stored measurements will stop blinking.
NOTE:
• The memory function cannot be used in “Multiple flash (cumulative) mode.”
• Measured values for ten times or more measurements will be displayed but cannot be
stored in memory.
1/10
f stop
Measured f stop
Memorized
f stop
Set shuttter speed
Number of memorized value
Memory button
Reference:
• When pressing Memory clear button @3 once,
the last memorized value is cleared. If you want
to clear all memorized values, please hold
down the Mode button
and press the
Memory clear button.
Reference:
• During Memory recall mode, when you press Memory clear button, the currently recalled
value is cleared.