Sony PEG-T415G - Manual (Page 12)

Chapter1 Basic operations of your Sony CLIÉ Handheld
12
Entering data into your Sony CLIÉ Handheld
Writing Graffiti letters
1
Tap where you want your text to go.
Note
You need to tap above the Graffiti writing area, and you must see a flashing cursor
before you write the text.
2
Use the tables on the following pages to find the stroke
shape for the letter you want to create. For example, the
stroke shown below creates the letter "n".
Note
There are two different stroke shapes available for some letters. For these letters,
choose the one that's easiest for you.
As you will see later, you use the same shape to create both the upper
case and lower case version of a letter.
3
Position the stylus in the left-hand side of the Graffiti writing
area.
4
Start your stroke at the heavy dot and draw the stroke shape
as it appears in the tables.
5
Lift the stylus from the screen at the end of the stroke shape.
That is all there is to it. When you lift the stylus from the screen, your
CLIÉ handheld recognizes your stroke immediately and prints the letter
at the insertion point on the screen.
As soon as you lift the stylus from the screen, you can begin the stroke for
the next character you want to write.
Lift stylus here
Start stroke at heavy dot
Position the stylus
Continued on next page