Sharp PG-M20X - Manual (Page 20)

Up Down
Foot releases
Adjustment feet
Setup
Using the Adjustment
Feet
The height of the projector can be adjusted
using the adjustment feet when the surface
of the projector is placed on is uneven or when
the screen is slanted.
The projection of the image can be made
higher by adjusting the projector when it is in
a location lower than the screen.
1
Press the foot releases.
2
Lift the projector to adjust its
height and remove your hands
from the foot releases.
3
Rotate the adjustment feet to
make minor changes.
Note
• When returning the projector to its origi-
nal position, hold the projector firmly, press
the foot releases and then lower it.
• The projector is adjustable up to approxi-
mately 5.5 degrees from the standard po-
sition.
Info
• Do not press the foot releases when the
feet are extended without firmly holding
the projector.
• Do not hold the lens when lifting or lower-
ing the projector.
• When lowering the projector, be careful not
to get your fingers caught in the area be-
tween the adjustment feet and the projector.
-16