Sharp PG-M20X - Manual (Page 23)

Setup and Connections
-19
When using the default setting.
▼On-screen Display
Projecting a Reversed/Inverted Image
Projection from behind the screen
■ Place a translucent screen between the projector and the
audience.
■ Reverse the image by setting “Rear” in “PRJ Mode”. See
page 60 for use of this function.
Projection using a mirror
■ Place a mirror (normal flat type) in front of the lens.
■ Reverse the image by setting “Rear” in “PRJ Mode”, when the
mirror is placed on the audience side. See page 60 for use of
this function.
Info
• When using a mirror, be sure to carefully position both the pro-
jector and the mirror so the light does not shine into the eyes of
the audience.
Ceiling-mount setup
■ It is recommended that you use the optional Sharp ceiling-mount
bracket for this installation.
Before mounting the projector, contact your nearest Sharp
Authorized Projector Dealer or Service Center to obtain the
recommended ceiling-mount bracket (sold separately.) (AN-
PGCM90 ceiling-mount bracket, its AN-EP101B extension tube
and AN-JT200 universal bracket, adaptor for non-level ceiling
installation (for U.S.A.), BB-M20T ceiling adaptor, its BB-
NVHOLDER280, BB-NVHOLDER550, BB-NVHOLDER900
ceiling mount systems (for GERMANY), or AN-60KT ceiling-
mount bracket, its AN-TK301/AN-TK201 and AN-TK302/AN-
TK202 extension tubes (for countries other than the U.S.A. and
GERMANY))
■ Be sure to adjust the position of the pro-
jector to match the distance (H) from
the lens center position (see page
18 )
to the lower edge of the image, when
mounting the projector on
the ceiling.
■ Invert the image by
setting “Ceiling + Front”
in “PRJ Mode”.
The image is reversed.
When using the default setting.
▼On-screen Display
The image is reversed.
When using the default setting.
▼On-screen Display
The image is inverted.