Sharp PG-M20X - Manual (Page 82)

Appendix
-79
Specifications
Digital Multimedia Projector
PG-M20X
NTSC 3.58/NTSC 4.43/PAL/PAL-M/PAL-N/PAL 60/SECAM/
DTV480I/DTV480P/DTV720P/DTV1080I
Single Chip Digital Micromirror Device™ (DMD™) by Texas Instruments
Panel size: 0.7" (17.8 mm), 1 chip XGA DMD
No. of dots: 786,432 dots (1,024 [H]
× 768 [V])
1–1.2 × zoom lens, F1.75–2.04, f = 28.0–33.5 mm
High Intensity Discharge Lamp (HID Lamp), DC 210 W
29-pin connector
DVI input signal: Digital 250–1,000 mV 50
Ω
Analog 0.7 Vp-p 75
Ω
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
P
B
: 0.7 Vp-p, 75
Ω terminated
P
R
: 0.7 Vp-p, 75 Ω terminated
700 TV lines (DTV720P)
29-pin connector
RGB separate/sync on green type analog input: 0–0.7 Vp-p, positive, 75
Ω terminated
HORIZONTAL SYNC. SIGNAL: TTL level (positive/negative)
VERTICAL SYNC. SIGNAL: Same as above
4-pin Mini DIN connector
Y (luminance signal): 1.0 Vp-p, sync negative, 75
Ω terminated
C (chrominance signal): Burst 0.286 Vp-p, 75
Ω terminated
RCA connector: VIDEO, composite video, 1.0 Vp-p, sync negative, 75 Ω
terminated
12–230 MHz
43–200 Hz*
15–126 kHz
ø3.5 mm M
INIJACK
: AUDIO, 0.5 Vrms, more than 47 k Ω (stereo)
2.0 W (monaural)
4 cm
× 3 cm
AC 100–240 V
3.2 A
50/60 Hz
290 W
1,090 BTU/hour
41
°F to 95°F (+5°C to +35°C)
–4 °F to 140°F (–20°C to +60°C)
Plastic
38 kHz
8
5 ⁄
8
" Ч 3" Ч 11 15 ⁄
16
" (219 (W) × 76 (H) × 303 (D) mm) (main body only)
8 3 ⁄
4
"
Ч 3 1 ⁄
4
"
Ч 12 1 ⁄
2
" (223 (W)
× 83 (H) × 318 (D) mm) (including adjustment feet
and projecting parts)
5.8 lbs. (2.6 kg)
Remote control, Two R-03 batteries, Power cord for U.S., Canada etc. (6', 1.8 m), Power
cord for Europe, except U.K. (6', 1.8 m), Power cord for U.K., Hong Kong and Singapore (6',
1.8 m), Power cord for Australia, New Zealand and Oceania (6', 1.8 m), DVI to 15-pin D-sub
cable (6', 1.8 m), USB cable (6', 1.8 m), Carrying case, Lens cap (attached), Lens cap
strap, Terminal cover (attached), CD-ROM, Operation manual, Quick reference guides
Lamp unit (Lamp/cage module) (BQC-PGM20X//1), Remote control (RRMCGA013WJSA),
Two R-03 batteries (“AAA” size, UM/SUM-4, HP-16, or similar), Power cord for U.S., Canada
etc. (QACCDA007WJPZ), Power cord for Europe, except U.K. (QACCV4002CEZZ), Power
cord for U.K., Hong Kong and Singapore (QACCB5024CENA), Power cord for Australia,
New Zealand and Oceania (QACCL3022CEZZ), DVI to 15-pin D-sub cable
(QCNWGA010WJZZ), USB cable (QCNWG0001WJPZ), Carrying case
(GCASN0005CESA), Lens cap (CCAPHA001WJ01), Lens cap strap (UBNDT0013CEZZ),
Terminal cover (GCOVD0103CESA), CD-ROM (UDSKA0058CEN2), Operation manual
(TINS-7609CEN1), Quick reference guides
Product type
Model
Video system
Display method
DMD panel
Lens
Projection lamp
Component input signal
(INPUT1)
Horizontal resolution
Computer RGB input signal
(INPUT 1)
S-video input signal
(INPUT 2)
Video input signal
(INPUT 3)
Pixel clock
Vertical frequency
Horizontal frequency
Audio input signal
Audio output
Speaker system
Rated voltage
Input current
Rated frequency
Power consumption
Heat dissipation
Operating temperature
Storage temperature
Cabinet
I/R carrier frequency
Dimensions (approx.)
Weight (approx.)
Supplied accessories
Replacement parts
This SHARP projector uses a DMD panel. This very sophis-
ticated panel contains 786,432 pixels. As with any high tech-
nology electronic equipment such as large screen TVs, video
systems and video cameras, there are certain acceptable
tolerances that the equipment must conform to. This unit has some inactive pixels within acceptable toler-
ances which may result in inactive dots on the picture screen.
This will not affect the picture quality or the life expectancy
of the unit.
Specifications are subject to change without notice.
* Temporary noise may be visible with vertical frequencies above 100Hz if OSD functions are activated.