Sharp PG-M20X - Manual (Page 67)

Setting the Anti-Theft (cont.)
When “Anti-Theft” is set, the keycode
inputting section appears after the
power is turned on. At that time, enter
the right keycode.
• Press the buttons on the remote control if
the buttons on the remote control are used
for setting the keycode. In the same manner,
press the buttons on the projector if the
buttons on the projector are used for setting
the keycode.
Info
• Once the function is activated, you must
remember the correct keycode. We
suggest you record the keycode in a safe
place where only authorized users will
have access. If you lose or forget your
keycode, you will need to contact your
nearest Sharp Authorized Projector Dealer
or Service Center (see page
78 ). You may
need to bring your projector to them to
restore the projector to original factory
condition (password and keycode reset).
Changing the Keycode
• When “Anti-Theft” is selected, the password
input box is displayed. After the password has
been entered, you can change the keycode.
Select “Anti-Theft” in the “Options (2)”
menu
➝ For details, see page
38 .
1
Press the buttons on the
remote control or the projector
to enter the preset 4-digit
keycode in “Old Code”.
2
Press any button you like on the
remote control or the projector
to enter the new keycode.
3
Enter the same 4-digit keycode
in “Reconfirm”.
Note
• If you do not want to set a keycode, leave
the keycode field blank in steps 2 and 3
and press
.
-64