Speco Technologies DVR-16/IP - Manual (Page 17)

16
DSCP Speed Dome
1 RS-485 ID Setup XXX
2 Zoom
3 Brightness
4 Set Preset Point XXX
5 Enter Speed Dome Menu
6 Exit
6.4.1.1 Install
This item allows you to install each channel on 1 Configuration Table1. Every channel is
“installed” by default; you may uninstall any one of them manually. Once a channel is
un-installed, all related functions are disabled (√ = camera installed; • = camera not installed).
6.4.1.2 Covert
This item allows you to make each camera’s input invisible (covert) on both main and call
monitor, while DVR-16/IP keeps recording the camera’s video. The default setting is every
camera visible (√ = covert; • = not covert).
6.4.1.3 PTZ
Set this item to enable, users can set the following external device
OSD settings through the DVR-16/IP front panel. Press the number
button corresponding to the wanted camera to make it full screen, and
then press the SET button to go to the “External Devices” Menu.
RS-485 Baud Rate
Baud rate is a number related to the speed of data transmission in your security
system. The higher the baud rate, the more bits per second that are transferred.
Before the data are transferred between two devices, you must ensure that both
devices are configured to the same transmission rate.
DSCP Speed Dome
This sub-menu is offered to adjust the dome settings. After
you are in the sub-menu, you can pan/ tilt the speed dome
freely by pressing SET and the direction buttons
simultaneously.
RS-485 ID Setup
If you want to control the DSCP Speed Dome through the front panel, you should
firstly check and modify the RS-485 ID here.
Zoom
Press the Enter button to enter the Zoom mode. You can simply push the right
direction button to zoom in (tele) and the left direction button to zoom out (wide).
Press the ESC button to exit the Zoom mode.
Brightness
Use the right and left direction buttons to adjust the brightness of the selected
dome camera. Press the ESC button to exit.
Set Preset Point
This item allows you to set the preset points. Pan/ Tilt the dome camera to the
wanted position and give the preset point a number, and then press the Enter
button.
Enter Speed Dome Menu
Press Enter on this item to go to the OSD menu of installed Speed Dome.
External Devices
1 RS-485 Baud Rate
2 DSCP Speed Dome
3 CHIPER CRT.V9KRP
4 PELCO Speed Dome
5 Exit