Sunwave Tech. SRC-3000b - Manual (Page 18)

SRC-3000B User’s Manual
14
B. Automatically Programming remote by Code
1. Please follow step1-4 stated in
Manual Entry section.
2. Turn on the target device you
want to control and point the SRC-
3000b to the target device.
3. Press to start Auto Search
Function. SRC-3000b will send out
IR codes to find the correct ones.
4. When the target device is turned
off, touch any part of the screen
immediately to stop the searching.
5. Press and to ascertain
that the codes are suitable for the
device. Test the
key if the
device is turned on again, this
means you have already found
the proper codes for your devices.
6. Press to save the codes in
SRC-3000b.
NOTES:
a. When getting the right codes, you can press to show
the four-digit code number. In this way, you can enter the
code number directly in the future.
b. You can press at any time to exit the mode without
saving any codes.
c. Each device can automatically search the target device
codes under the same classification only. For example,
within TV device, Auto Search will just find the codes for TV.