Sherwood RX-773 - Manual (Page 12)

ENGLISH
12
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of about 7 meters
(23 feet) and angles of up to 30 degrees aiming at the
remote sensor.
• When the remote control does not operate, the old batteries should be replaced. In this case, load new batteries within several
minutes after removing old batteries.
• If the batteries are removed or have been exhausted for a longer period of time, memorized contents will be cleared.
Should this happen, you should memorize them again.
• Remove the batteries when they are not used for a long
time.
• Do not use the rechargeable batteries (Ni-Cd type).
• Be sure to use alkaline batteries.
1.
Enter the setup code for each component other than
this receiver. For details, refer to “Entering a setup
code” on page 13.
2.
Turn on the component you want to operate.
1.
Remove the cover.
2.
Load two batteries ("AAA" size, 1.5V) matching the
polarity.
3.
Press the DEVICE button on the remote control
corresponding to the component you wish to operate.
4.
Aim the remote control at the REMOTE SENSOR of
the component you wish to control and press the
button corresponding to the operation you want.