Sherwood RX-773 - Manual (Page 13)

ENGLISH
13
USING FUNCTIONS OF REMOTE CONTROL
Entering a setup code
• This remote control can control up to 8 different components.
• Before operating audio and video components other than this receiver with using this remote control, the setup code for each
component should be entered.
• For system remote control operation, "000" was stored previously in the memory of the device button "CD" for Sherwood CD
player, "DVD" for Sherwood DVD player, "AUX" for Sherwood tape deck and "TV" for Sherwood TV respectively as its factory
setup code. So, you don’t need to enter its code for each Sherwood component except in such a case that its code does not
work.
• The LED will flicker once.
Note : The “AUD” button is unavailable for the audio
components other than this receiver.
1.
Turn on the component you want to operate.
2.
Find the setup codes according to the type and the
brand name of your component, referring to "Setup
Code Table" on page 28.
3.
Press and hold down both the “ENTER/MEMORY”
button and the desired one of the DEVICE buttons for
more than 1 seconds.
4.
Enter a 3 digit code, aiming the remote control at the
remote sensor on the component.
• If entering is performed successfully, the LED will flicker
twice.
• To be sure that the setup code is correct, press the POWER
ON(or STANDBY) button.
If your component is tuned off, the setup code is correct.
• When your component is not turned off, repeat the above
steps 2 to 4, trying each code for your component until you
find one that works.
Notes:
• If the LED did not flicker twice, then repeat the above
steps 3 to 4 and try entering the same code again.
• Manufacturers may use different setup codes for the same
product category. For that reason, it is important that you
check to see if the code you have entered operates as
many controls as possible. If only a few functions operate,
check to see if another code will work with more buttons.
Example) When entering "001".
5.
Repeat the above steps 1 to 4 for each of your
components.