Sherwood RX-773 - Manual (Page 18)

When adjusting the bass
When adjusting the treble
ENGLISH
18
Adjusting the sound volume balance
• “TON DIR” is displayed, “DIRECT” lights up and the sound
that bypasses the tone circuitry will be heard.
• To cancel the tone direct function, press this button again
to display “TON CTRL”, and then “DIRECT” goes off.
• Each time the buttons are pressed, the balance level can
be adjusted within the range of L 10~R 10.
Note : In general, the balance level is adjusted to 0.
10.
Adjust the sound volume balance between the left and right speakers.
9.
To listen to a program source without the tone effect.
or
Adjusting the tone (bass and treble)
8.
Adjust the tone as desired.
• Each time the buttons are pressed, the tone (BASS and
TRBL) can be adjusted within the range of -10~+10 dB.
Notes :
• When the tone direct function is activated, the tone mode
cannot be entered and “TON DIR” flickers for 3 seconds.
• Extreme settings at high volume may damage your
speakers.
• In general, the bass and treble levels are adjusted to 0.
or
or
or