Spectrum Brands MC.31XX - Manual (Page 13)

Introduction Hardware information
(c) Spectrum GmbH 13
Dynamic Parameters
Dynamic parameters are measured at ± 1 V input range (if no other range is stated) and 50 Ohm termination with the samplerate specified in the table. Measured parameters are aver-
aged 20 times to get typical values. Test signal is a pure sine wave of the specified frequency with > 99% amplitude. SNR and RMS noise parameters may differ depending on the quality
of the used PC. SNR = Signal to Noise Ratio, THD = Total Harmonic Distortion, SFDR = Spurious Free Dynamic Range, SINAD = Signal Noise and Distortion, ENOB = Effective Number
of Bits. For a detailed description please see application note 002.
Order information
MC.3110
MC.3111 MC.3112 MC.3120
MC.3121 MC.3122 MC.3130
MC.3131 MC.3132
Test - Samplerate 1 MS/s 1 MS/s 10 MS/s 10 MS/s 25 MS/s 25 MS/s
Testsignal frequency 90 kHz 90 kHz 1 MHz 1 MHz 1 MHz 1 MHz
SNR (typ) > 67.5 dB > 66.9 dB > 64.9 dB > 64.9 dB > 63.1 dB > 62.4 dB
THD (typ) < -62.8 dB < -62.8 dB < -62.5 dB < -62.5 dB < -62.5 dB < -62.5 dB
SFDR (typ), excl harm. > 80.8 dB > 80.5 dB > 80.5 dB > 78.5 dB > 79.5 dB > 79.3 dB
SINAD (typ) > 61.5 dB > 61.4 dB > 60.5 dB > 60.5 dB > 59.8 dB > 59.4 dB
ENOB (based on SINAD) > 9.9 LSB > 9.9 LSB > 9.8 LSB > 9.8 LSB > 9.6 LSB > 9.6 LSB
Order No Description Order No Description
MC3110 MC.3110 with 8 MSample memory and drivers/SBench 5.x MC3xxx-16M Option: 16 MSample memory instead of 8 MSample standard mem
MC3111 MC.3111 with 8 MSample memory and drivers/SBench 5.x MC3xxx-32M Option: 32 MSample memory instead of 8 MSample standard mem
MC3112 MC.3112 with 8 MSample memory and drivers/SBench 5.x MC3xxx-64M Option: 64 MSample memory instead of 8 MSample standard mem
MC3120 MC.3120 with 8 MSample memory and drivers/SBench 5.x MC3xxx-128M Option: 128 MSample memory instead of 8 MSample standard mem
MC3121 MC.3121 with 8 MSample memory and drivers/SBench 5.x MC3xxx-256M Option: 256 MSample memory instead of 8 MSample standard mem
MC3122 MC.3122 with 8 MSample memory and drivers/SBench 5.x MC3xxx-up Additional handling costs for later memory upgrade
MC3130 MC.3130 with 8 MSample memory and drivers/SBench 5.x
MC3131 MC.3131 with 8 MSample memory and drivers/SBench 5.x MC3xxx-mr Option Multiple Recording: Memory segmentation
MC3132 MC.3132 with 8 MSample memory and drivers/SBench 5.x MC3xxx-gs Option Gated Sampling: Gate signal controls acquisition
MC3xxx-dig Additional 4 synchronous digital inputs per channel, incl. cable
MC3xxx-smod Star Hub: Synchronisation of 2 - 16 boards, one option per system
MC3xxx-time Timestamp option: Extra memory for trigger time MC31xx-dl DASYLab driver for MC.31xx series
MCxxxx-xmf Extra I/O, external connector: 24 DI/O, 4 Analog out, incl. cable MC31xx-hp VEE driver for MC.31xx series
MC31xx-lv LabVIEW driver for MC.31xx series
MC3xxx-cs Synchronisation of 2 - 4 boards, one option per system MATLAB MATLAB driver for all MI.xxxx, MC.xxxx and MX.xxxx series.
Cab-3f-9m-80 Adapter cable: SMB female to BNC male 80 cm Cab-3f-9f-80 Adapter cable: SMB female to BNC female 80 cm
Cab-3f-9m-200 Adapter cable: SMB female to BNC male 200 cm Cab-3f-9f-200 Adapter cable: SMB female to BNC female 200 cm