Spectrum Brands MC.31XX - Manual (Page 25)

Software Driver Installation Windows NT
(c) Spectrum GmbH 25
Windows NT
Installation
Under Windows NT the
Spectrum driver must be in-
stalled manually. The driver is
found on CD in the directory
\Install\WinNTDrv. Please
start the „Setup.exe“ pro-
gram. The installation is per-
formed totally automatically,
simply click on the „Next“
button. After installtion the
system must be rebooted
once (see picture on the right
side). The driver is install to
support one PCI/PXI or Com-
pactPCI device. If more boards are installed in the system the configuration of the driver has to be changed. Please see the following chapter
for this topic.
Adding boards to the Windows NT driver
The Windows NT driver
must be configured by the
Driver Configuration utility
to support more than one
board. The Driver Configu-
ration utility is automatical-
ly installed with the driver.
The Utility can be found in
the start menu as „DrvCon-
fig“.
To add a new card please follow these steps:
• Increase the board number on top of the screen by pressing the right button
• Change the board type from „Not Installed“ to „PCI Board“
• Press the „Apply changes“ button
• Press the „OK“ button
• Restart the system
Driver - Update
If a new driver version should be installed no Spectrum board is allowed to be in use by any software. So please stop and exit all software
that could access the boards.
When updating a system please simply execute the setup file of the new driver version. Afterwards the system has to be rebooted. The driver
configuration is not changed.