Symbol Technologies 1813-A2-GB20-00 - Manual (Page 36)

1813 VoIP Gateway User’s Guide
Chapter 7 Software Upgrade via FTP
Follow the steps below to upgrade the firmware version of the Gateway via FTP.
The procedures below use LAN port IP address 192.168.1.101 for illustration.
STEP 1: Connect the Gateway to a PC using the LAN cable. Set the PC to the same subnet as
the Gateway (192.168.1.101).
STEP 2: Start an FTP program on the PC.
STEP 3: Start DOS and enter the menu where the new firmware is installed:
Example: C:\Upgrade
STEP 4: Enter the command: ftp 192.168.1.101 (Gateway’s IP address)
STEP 5: At the USER prompt type root (small case)
STEP 6: At the Password prompt type 1234
STEP 7: After you see the message User Logged in, type: Bin
STEP 8: After you see the message Type set to I, type: ha
STEP 9: After you see the message Hash mark printing, type:
put <filename.bin> app
Example: put firmware app
36