Symbol Technologies 1813-A2-GB20-00 - Manual (Page 9)

1813 VoIP Gateway User’s Guide
Chapter 2 Hardware Installation
2.1 Reset Button
The figure below illustrates the back panel of the Gateway. On the left side of the rear panel
there is a reset button. This button is used to reload the factory default settings. Use a small
object like a ballpoint pen to press the button and hold it down for over three seconds. The
Gateway will be reset and all parameters will return to their factory default settings. You can
verify this process by monitoring the PHONE LED. It will turn off and then on again as the
Gateway restarts.
LAN
POWER WAN
PHONE
3X
2X
1X
04-17596
9