Sharp Conference Series XG-V10WU - Manual (Page 39)

E-38
Operation Buttons
Connecting the Mouse Receiver
Connecting the Remote Mouse Receiver
You can use the remote control as a remote mouse to operate computers
compatible with PS/2 or USB type mouse systems.
1.2.3 4.5.6
Conference Series
1 Connect one end of the supplied USB mouse control cable to the corresponding terminal on the computer.
2 Connect the other end to the USB port on the remote mouse receiver.
USB port
USB mouse control
cable
QCNW-5680CEZZ
Remote mouse
receiver
RUNTK0673CEZZ
Use the USB port
(PC or Macintosh) to
connect the supplied
USB mouse control
cable to the remote
mouse receiver.
1 Turn off the power of the PC.
2 Connect one end of the supplied PS/2 mouse control cable to the corresponding terminal on the PC.
3 Connect the other end to the PS/2 port on the remote mouse receiver.
4 Turn on the power of the PC.
CAUTION
• Do not connect or disconnect the mouse control cables to or from the computer while it is on.
This may damage your computer.
• Do not connect both the PS/2 and USB mouse control cables to the remote mouse receiver.
• Windows 95 does not support USB mouse driver software.
• The minimum system requirements for the USB type mouse system are shown below.
Windows
Hardware: PC/AT compatible machine with USB port that has Windows 98/Windows NT 5.0 or
higher installed.
OS: Windows 98/Windows NT 5.0 or higher
Macintosh
Hardware: Macintosh series with USB port
OS: Mac OS 8.5 or higher
Remote mouse
receiver
RUNTK0673CEZZ
PS/2 mouse control
cable
QCNW-5113CEZZ
PS/2 port
Use the PS/2 port
(PC) to connect the
supplied PS/2 mouse
control cable to the
remote mouse
receiver.
Connecting to the USB port on a PC or Macintosh
Connecting to the PS/2 port on a PC