Samsung SP-H800 - Manual (Page 15)

Preparation
Installation and Basic Adjustments
15
1. Plug the power cord into the power terminal on the rear side of the projector.
2. Press and push the power switch on the rear side of the projector toward "-".
3. Press the POWER button of the projector or the ON button of the remote control.
4. A picture will be displayed on the screen in approximately 30 seconds.
2 3 1
2 3 1
INSTALLATION AND BASIC ADJUSTMENTS
Turning ON/OFF
Turning On Projector
1. Press the [POWER] button on the projector or the [OFF] button on the remote control.
2. Select the [OK] button displayed on the screen.
3. Do not unplug the power cord from the wall outlet , and do not press the <O> side of the
power switch at the back of the projector during the cooling time (approximately one and
a half minutes). Insufficient cooling may reduce the life time of the product. During the
cooling time, the [LAMP] operating LED on the main body blinks.
4. When the cooling operation is successfully completed, the [LAMP] operating LED on the main
body is turned off and the [STAND BY] operating LED is turned on. Press the <O> side of the
power switch at the back of the projector to minimize standby power consumption.
Turning the power OFF
NOTE
■ When you turn off the projector, the cooling fan
stops within 1 minute and 30 seconds.
■ When the cooling fan stops, push the power
switch toward "O" and unplug the power cord.
OK
Turn Power Off?
Cancel