Samsung SP-H800 - Manual (Page 83)

Lamp Replacement
Other Information
Lamp Replacement
83
The projector lamp is
installed at the bottom of the
projector. Turn the projector
over so that the base plane
faces upward and remove the
screws on the lamp cover. Push to open the lamp cover
in the direction of the arrow.
Detach the three screws.
Lift up and hold the lamp
handle and pull the lamp
module out as shown in the
following figure.
2 3
4
6 5 Reverse the disassembly
procedure to assemble the
unit after replacement.
■ The projector lamp is en expandable supply. For best operating performance, replace the
lamp according to the usage time. You can view the lamp usage time in the Information
Display (INFO button).
■ Use the recommended lamp when replacing. Lamp specifications are defined in the user’s
manual. Replace with the same model provided with the projector.
- Lamp Model Name : LAMP-MERCURY-Philips
- Lamp Manufacture : Philips Lighting
- Lamp Life Time
: 2000Hrs
- Lamp Type : 250W UHP
- Lamp Part Number : BP47-00010A
■ Check that the power cord is unplugged before replacing lamps.
■ Even after the power cord has been disconnected, the lamp will be hot. Allow it to cool
down for at least 1 hour before changing the lamp.
■ The projector lamp is installed at the bottom of the projector.
■ Before you turn the projector over to change the lamp, cover the projector with a soft cloth
on a flat surface.
■ Do not leave the old lamp near inflammables or in reach of children. There is a danger of
burn or injury.
■ Remove dirts or foreign materials around or inside the lamp unit using a proper vacuum
device.
■ Be careful not to touch the lamp itself when handling the lamp unit.
■ If the lamp is poorly handled, it may result in poor picture quality or shorter life time of
lamp.
■ The projector is will not operate normally if the cover is not locked completely after lamp
replacement. Refer to LED information in the user’s manual if the projector does not operate
normally.
Cautions on Lamp Replacement
Lamp Replacement Procedure
The lamp is very hot and operates
with a high voltage. Allow it to
cool down for at least 1 hour after
disconnecting the power cord
before changing the lamp. 1