Stinger MC POWER SYSTEM MC2 - Manual (Page 13)

MC 2 Power Systems User's Guide Chapter 1: Quick Setup
Chapter 1: Quick Setup
Note:
The quick setup information in this chapter pertains to both the 26 Amp-Hour and 35
Amp-Hour units.
Use the references in the following table to obtain further information about your unit to
assist you during the set up process:
MC2 Power System See page
26 Amp-Hour Unit
Identifying the Power System 5
Preparing for Operation 6
User-Selectable Switch Settings 9
35 Amp-Hour Unit
Identifying the Power System 11
Preparing for Operation 13
User-Selectable Switch Settings 15
If the power system unit was sent alone:
1 Unpack the power system unit and check for any physical damage.
2 For the MC 2 Power System Series 26 Amp-Hour units, connect and secure the
electronic and battery enclosure together. For the MC
2
Power System Series 35
Amp-Hour units, the Power Output Disconnect Switch (depicted below) must be in
the ‘ON’ position:
Power output disconnect switch location
3 Verify that all LED indicators for each power output channel are ON.
1110227 Revision 2
November 2006 1