Stinger MC POWER SYSTEM MC2 - Manual (Page 34)

Chapter 6: Power System Management Software MC2 Power Systems User's Guide
Installing the Advanced Power Monitor Software
Note:
The Advanced Power Management Software is available for use with both the 26 Amp-
Hour and 35 Amp-Hour units.
The Advanced Monitoring software does not offer the ability to perform an auto-run of the
software installation. Manual installation of the software is required to load the
application and the USB driver.
1 Navigate to the CD-ROM drive or the disk folder location where the installation files
reside.
2 Double-click the setup.exe file. The following window is displayed:
The following window is displayed:
3 Click OK. The following window is displayed:
1110227 Revision 2
22 November 2006