Sony BRC-Z330 - Manual (Page 31)

O
per
a
tio
n
U
s
in
g
th
e S
upp
lied
Remo
te
Comma
nde
r
Turning on the Power
31
Before operating, check that the camera and peripheral
devices are properly installed and connected.
For details, see “Installation” (page 43) and
“Connections” (page 51).
Turning on the Power
1
Connect the camera to an AC outlet using the
supplied AC power adaptor and power cord.
The power is turned on and the POWER lamp
lights.
The camera will automatically pan and tilt and be
reset to the position stored in POSITION 1 (Pan/tilt
reset action).
2
Turn on the peripheral devices.
To turn on/off the camera using the
Remote Commander
As long as the camera is connected to an AC outlet, you
can turn the camera on or off with the POWER switch
on the Remote Commander.
When you turn the power off using the Remote
Commander, the POWER lamp turns off and the
STANDBY lamp lights on the camera.
Note
When you turn off the camera using the Remote
Commander, the camera tilts downward to protect the
lens from dust before entering Standby mode. When
IMG-FLIP is set to ON in the SYSTEM menu, however,
the camera tilts the opposite way so that the lens faces
downward when the camera is installed suspended from
a ceiling.
Operation Using the Supplied
Remote Commander
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
VIDEO
IR SELECT
75
1
2
3
OFF ON DATA MIX OFF ON
IN VISCA RS-232C OUT S VIDEO
!
DC IN 12V
R
to AC outlet POWER lights
POWER
CAMERA SELECT
1 2 3
AUTO
BACK LIGHT
MANUAL
FAR
FOCUS
NEAR
DATA SCREEN
POWER STANDBY lights