Sony BRC-Z330 - Manual (Page 44)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
44
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed.
Notes
• You should take an appropriate countermeasure to
prevent the camera from falling.
• Do not grasp the camera head when carrying the
camera.
• Do not turn the camera head by hand. Doing so may
result in the camera malfunctioning.
To attach the camera to a tripod
Attach a tripod to the screw hole used for attaching a
tripod on the bottom of the camera.
The tripod must be set up on a flat surface and tightened
firmly by hand.
Use a tripod with screws of the following specifications.
Installing the Camera in a High
Position
Using the supplied ceiling brackets, wire rope, and
screws, you can attach the camera to a ceiling or on a
shelf, etc. in a high position. You can also utilize an
existing junction box, etc. to attach the camera to a
ceiling.
When you install the camera, always install it on a level
ceiling or shelf, etc. If you have to install it on an incline,
make sure that the inclination is within ± 15 degrees, so
that the pan/tilt performance is guaranteed.
Before installation
The connecting cables cannot be passed through the
ceiling bracket (A). A hole for the wiring is required in
the ceiling or shelf, etc. behind where the camera is to be
installed. When installing the camera on a ceiling, make
the required hole for the junction box in the ceiling.
When installing it on a shelf, etc. in a high position, a
hole with a diameter of 70 mm (2
7
/ 8 inches) is required
for the protrusions of the ceiling bracket.
Make these holes after deciding the shooting direction.
1 / 4 -20UNC
= 4.5 – 7 mm
= 0.18 – 0.27 inches
Installation of the camera using the tripod screws and
screw holes should not be done for installation on a
ceiling or a shelf, etc. in a high position.
• When you attach the camera to a ceiling or shelf, etc.
in a high position, entrust the installation to an
experienced contractor or installer.
• Attach the camera to the ceiling or shelf, etc. firmly,
after making sure the ceiling, shelf, etc. and the
attachment materials (not including the supplied
accessories) are strong enough to bear a weight of 40
kg (88 lb 2 oz). If the ceiling or shelf, etc. is not
strong enough, the camera may fall and cause
serious injury.
• Be sure to attach the supplied wire rope to prevent
the camera from falling.
• Check periodically, at least once a year, to ensure
that the connection has not loosened. If conditions
warrant, make this periodic check more frequently.
Caution
Caution